|
PLEASE PATRONIZE OUR SPONSORS!
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
#1
06-29-2011, 01:44 PM
|
||||
|
||||
126 Grill Screen Retainer Spring?
I finally found a grill screen for my 126. Have looked around 2 local hardware stores and haven't had any luck finding the cone springs that are used to hold grill in place. Still haven't tried Ace,True Value, or Tractor Supply yet. If I don't have any luck finding anything do yall have any other ways that you install these screens ? Thanks in advance.
__________________
Cub 126 w/creeper & lift assist, IH wheel weights, Rear Lift, 10" Plow, IH front blade, QA42A Snow Thrower Cub 149 w/48" mower deck, wheel weights  
|
|
#2
06-29-2011, 02:41 PM
|
||||
|
||||
You are probably not going to find them anywhere like a hardware store. Our Sponsors up at the top of the page will have them and you can still get them from Cub Cadet Part #: IH-391347-R2 About $8/ea.
__________________
DWayne 1973: 128, ag tires, 3pt. lift, spring assist, lights, 42" Deck 10" moldboard plow 2016 XT1 42" deck 18HP
|
|
#4
05-14-2013, 10:06 PM
|
||||
|
||||
|
If you know what they look like they are not hard to make, especially if you have one setting there.
 Grab a piece of spring wire with needle nose pliers, so the end of the wire is pointing down towards the plier handles. Wrap the spring wire down the jaws of the pliers, you get the cone shape. Bend the piece you had in the jaws of the pliers to the "L" shaped hook. Cheap too, if you have access to some spring wire. 
|
|
#5
05-14-2013, 10:20 PM
|
|||
|
|||
|
I'm not entirely sure of that spring's purpose, but if McMaster-Carr (www.mcmaster.com) and Carr Lane (www.carrlane.com) don't have it, you've got an odd animal indeed!!!
|
|
#6
05-14-2013, 11:55 PM
|
|||
|
|||
|
I would swear I saw them in a store somewhere one time, but for the life of me I can't remember where.
But no, they aren't the kind of thing that you pick up at the local hardware store.
__________________
More IH Cub Cadet Parts RIGHT HERE
|
|
#8
05-15-2013, 01:10 PM
|
||||
|
||||
|
In the cast iron grill there are two tabs with eyes, one on each side. The grill pushes up against these eyes from the front, and the grill spring is inserted against the eye from the backside, with the hook going through the eye, through the grill, then you turn it 45 degrees or so, and lock it around the grill metal.
Hope this helps. When I get home this afternoon, I will tajke a pic.
__________________
John Proud Owner of a Model 100 and a Model 124. A homemade cart, 2 x 42" mower decks, a 38" deck, a 42" front NF blade, and a lawn sweeper!
|
|
#9
05-15-2013, 03:23 PM
|
||||
|
||||
|
I've got screws holding my screen in place. That being said, I do not have the correct screen for the front of my 147.
__________________
Daniel G. . (May 1970) 147 w/an IH spring assist, 48" deck, 42" blade, 1969 73, #2 trailer, 10" Brinly plow and (on loan) Dad's #2 tiller.
|
|
|
|
Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.
MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.
This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC
All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.
Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.
Linear Mode
