|
PLEASE PATRONIZE OUR SPONSORS!
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
#1
01-02-2023, 01:07 PM
|
|||
|
|||
Splitting my 125
Look how bad my trunnion is. I’ve started splitting my 125 today. My shop manual doesn’t say anything about my three point lift linkage, will I have to remove it to get my tractor apart? Also it says I must remove the brake rod but the hydraulic oil filter is in the way. Do y’all just remove the oil filter to get your brake rod out?
|
|
#2
01-02-2023, 01:32 PM
|
|||
|
|||
|
I don't know how the three point fits into the equation since my doesn't
have one but I do know. You do not need to take the filter off. In fact I would want it on there going in and out to keep crud out of the hydro. You should be able to take the break rod apart. Just follow it up from the brake going into the rear end and disconnect the first break in it you come to. Or take it apart right at the brake itself. Ken
|
|
#4
01-02-2023, 01:51 PM
|
|||
|
|||
|
I got it out without removing the filter. The part that has the Chevy bow tie seems to have the most wear. Can that be shimmed up? The trunnion springs won’t stay in place. No wonder my hydro was erratic.
|
|
#5
01-02-2023, 01:53 PM
|
|||
|
|||
|
Up close to the hydro unit.
|
|
#7
01-02-2023, 02:59 PM
|
|||
|
|||
|
I welded mine up and filed it back to spec, using a piece of 3/4" key stock as a guide. I could have milled it, but this was pretty quick and easy. I then very slowly and carefully put the arm under the press to get it centered in the trunnion, checking it several times to get it just right. My springs were in spec, but I may still put a couple of thin shim washers in there anyway. Sam Mac had a thread on him doing that.
|
|
#8
01-02-2023, 03:01 PM
|
|||
|
|||
|
Trunnion after cleaning. It doesn’t look that bad, it’s the bow tie piece and the piece the control rod connects to that are so sloppy. I have .030” of gap between the external snap ring and the bow tie piece at the fulcrum. There is .025” between the snap ring and the piece that moves the bow tie piece at its fulcrum. I’m sure shims will help my slop. I need both springs and their retainers as well. You guys already connected me with a guy that rebuilds relief valves, so I have enough to keep me busy next weekend.
|
|
#10
01-02-2023, 03:07 PM
|
|||
|
|||
|
That looks great!
|
|
|
|
Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.
MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.
This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC
All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.
Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.
Linear Mode
