Only Cub Cadets

PLEASE PATRONIZE OUR SPONSORS!

CC Specialties R. F. Houtz and Sons Jeff in Pa.

P&K Cub Cadet Machtech Direct

Cub Cadet Parts & Service


If you would like to help maintain this site & enhance it, feel free to donate whatever amount you would like to!




Attention Guest, We have turned off the forum to guest. This is due to bots attacking the site. It is still free to register.

-->
Go Back   Only Cub Cadets > Cub Cadets > IH Cub Cadet Tractors (GT)

Notices

Reply
 
Thread Tools Display Modes
  #1  
Old 11-19-2020, 07:19 PM
jchristensen jchristensen is offline
Member
 
Join Date: Jan 2011
Location: Texas
Posts: 47
Default Original clutch troubles

I'm almost finished with my 1962 Original restoration and I'm having trouble getting the clutch right. I referenced the manual for instructions when I assembled it, but now on the tractor it doesn't stop the drive shaft when you push the clutch pedal down and the gears grind.
I've adjusted the linkage to pull back farther, it got better, but not completely solved. So I adjusted it another turn and had to get a pry bar to pull the throw out housing back enough to get the pin in place. It got a little better, but now it almost feels like the clutch isn't fully engaged. What I mean by that is if you pop the pedal free it doesn't throw you out of the seat like my 71 it just sorta gently engages.
The lining on the clutch showed very little wear and the tractor seemed to drive fine before except that the teaser spring was broken.
Reply With Quote
  #2  
Old 11-19-2020, 11:14 PM
docmirror's Avatar
docmirror docmirror is offline
Member
 
Join Date: Oct 2020
Location: TX
Posts: 97
Default

I've only done this once, and I'm no expert, but what I did is to start at the travel listed in the manual. Then, I adjusted the brake rod so it starts deeper in the pedal travel, giving me more free throw for the clutch. That way, my clutch gets a bit more power and I can get that 'jerk' forward in 2nd gear. My change to the book value was on the brake rod, not the clutch. Seems to work well.
Reply With Quote
  #3  
Old 11-21-2020, 11:21 AM
jchristensen jchristensen is offline
Member
 
Join Date: Jan 2011
Location: Texas
Posts: 47
Default

I figured it out. The drive belt was too tight. It must have been pulling the drive shaft slightly out of alignment and causing the front plate to rub on the clutch disc a bit.
I adjusted the clutch linkage back to the measurements in the book and it's perfect.
Reply With Quote
  #4  
Old 11-25-2020, 09:08 PM
jbrewer's Avatar
jbrewer jbrewer is offline
Grand Member
 
Join Date: Sep 2011
Location: NC
Posts: 2,606
Default

Good diagnostic work!

Glad you got it going. Doesn't it feel great to win?
__________________
61 and 63 Originals
123 (2)
782D
106,
147, 122
102
parts

It's only original ONCE!
Reply With Quote
Reply

Tags
clutch, original


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 03:37 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.

Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.

MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.

This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC

All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.

Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.