Only Cub Cadets

PLEASE PATRONIZE OUR SPONSORS!

CC Specialties R. F. Houtz and Sons Jeff in Pa.

P&K Cub Cadet Machtech Direct

Cub Cadet Parts & Service


If you would like to help maintain this site & enhance it, feel free to donate whatever amount you would like to!




Go Back   Only Cub Cadets > Cub Cadets > IH Cub Cadet Tractors (GT)

Notices

Reply
 
Thread Tools Display Modes
  #1  
Old 01-19-2014, 03:35 PM
Giotundo Giotundo is offline
Member
 
Join Date: Dec 2013
Location: MD
Posts: 41
Default Hydro won't move

Hey fellas I just changed the filter and fluid in my new 125 and now I can move about a foot in reverse and nothing going foward. I changed everything because the gasket was slightly leaking and it'd never been change yet since I owned it. Any ideas what the problem is I'm very new to this.
Reply With Quote
  #2  
Old 01-19-2014, 03:52 PM
R Bedell R Bedell is offline
Founding Member
 
Join Date: Mar 2007
Location: Michigan
Posts: 13,693
Default

What filter and fluid did you use..???
__________________
[B]Roland Bedell[/B]

CC Models: 100, 105, 1450, 782, (2) 784, & 2072

[SIZE="4"][B][COLOR="Red"]Buy:[/COLOR][COLOR="Blue"] Made in the USA[/COLOR][/B] [/SIZE]:American Flag 1:
Reply With Quote
  #3  
Old 01-19-2014, 03:59 PM
Muzzy Muzzy is offline
Senior Member
 
Join Date: Oct 2012
Location: Massachusetts
Posts: 497
Default

And how much fluid did you put in?
Reply With Quote
  #4  
Old 01-19-2014, 04:12 PM
Giotundo Giotundo is offline
Member
 
Join Date: Dec 2013
Location: MD
Posts: 41
Default

It's the correct trans filter and I put just shy of two gallons of hytran. I filled till it poured out the fill hole. Ran it for a while tried to move it foward and reverse then topped it off.
Reply With Quote
  #5  
Old 01-19-2014, 04:18 PM
Muzzy Muzzy is offline
Senior Member
 
Join Date: Oct 2012
Location: Massachusetts
Posts: 497
Default

Is the lever for the pressure relief valves on?
Reply With Quote
  #6  
Old 01-19-2014, 04:19 PM
R Bedell R Bedell is offline
Founding Member
 
Join Date: Mar 2007
Location: Michigan
Posts: 13,693
Default

Is the "input shaft" to the hydro unit rotating..???
__________________
[B]Roland Bedell[/B]

CC Models: 100, 105, 1450, 782, (2) 784, & 2072

[SIZE="4"][B][COLOR="Red"]Buy:[/COLOR][COLOR="Blue"] Made in the USA[/COLOR][/B] [/SIZE]:American Flag 1:
Reply With Quote
  #7  
Old 01-19-2014, 04:45 PM
Giotundo Giotundo is offline
Member
 
Join Date: Dec 2013
Location: MD
Posts: 41
Default

The input shaft is spinning and the lever is in the drive position.
Reply With Quote
  #8  
Old 01-19-2014, 05:10 PM
Muzzy Muzzy is offline
Senior Member
 
Join Date: Oct 2012
Location: Massachusetts
Posts: 497
Default

Did you clean out the rearend good When you drained it? It sounds like a plugged filter or the wrong filter.
Reply With Quote
  #9  
Old 01-19-2014, 05:23 PM
Giotundo Giotundo is offline
Member
 
Join Date: Dec 2013
Location: MD
Posts: 41
Default

I cleaned all the gunk out then sprayed with brake cleaner and wiped it all down. The filter is from ihccw and says it's for a cub 125 hydro. I'm 90% sure it's the correct filter unless I was sent the wrong one it says it right on it though.
Reply With Quote
  #10  
Old 01-19-2014, 05:29 PM
Muzzy Muzzy is offline
Senior Member
 
Join Date: Oct 2012
Location: Massachusetts
Posts: 497
Default

It seems like you did everything right.
Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 04:01 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.

Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.

MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.

This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC

All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.

Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.