Only Cub Cadets

PLEASE PATRONIZE OUR SPONSORS!

CC Specialties R. F. Houtz and Sons Jeff in Pa.

P&K Cub Cadet Machtech Direct

Cub Cadet Parts & Service


If you would like to help maintain this site & enhance it, feel free to donate whatever amount you would like to!




Attention Guest, We have turned off the forum to guest. This is due to bots attacking the site. It is still free to register.

-->
Go Back   Only Cub Cadets > Cub Cadets > IH Cub Cadet Tractors (GT)

Notices

Reply
 
Thread Tools Display Modes
  #1  
Old 03-31-2012, 12:18 PM
lwrehm lwrehm is offline
Member
 
Join Date: Jul 2010
Location: Wisconsin
Posts: 78
Default K321 Timing

I need a sanity check...where is the sight hole on a k321?

I was about to use Matt's K-Series Static Ignition Timing instructions to set the timing on my 149 but I can't find the sight hole on the flywheel cover. This is my first 14hp tractor other are all 10hp and 12hp, those I find right were I would expect them, but the 14hp doesn't have a hole on either side.
Reply With Quote
  #2  
Old 03-31-2012, 01:11 PM
TheSaturnV's Avatar
TheSaturnV TheSaturnV is offline
Grand Member
 
Join Date: Apr 2010
Location: OK
Posts: 1,344
Default

Look over by the S/G mounting bracket. Follow along and below the bracket and there it is, a little less than dime size. If the S/G is off you can't miss it.
Reply With Quote
  #3  
Old 03-31-2012, 01:31 PM
lwrehm lwrehm is offline
Member
 
Join Date: Jul 2010
Location: Wisconsin
Posts: 78
Default

I think I found it, not a round hole in the flywheel shroud, but a cresent shaped "notch" in the bearing plate, and WOOHOO I finally got a spark!!!!!

Now I just need to fix the spark plug threads in the head and we will see is this bugger will start....mouse nest in the flywheel sure does stink!!!

Good news, since I pulled the head off I got to clean up the carbon, and I found that it still has standard bore so me sees a rebuild in the future!

I also picked up some 10-24 1/4" cap bolts, putting it back together with a hex key is a whole lot easier than flat head screws.
Reply With Quote
  #4  
Old 05-18-2013, 09:54 PM
esleighton esleighton is offline
New Member
 
Join Date: Sep 2012
Location: Vermont
Posts: 7
Default K321A timing mark

Here is a pic. Note the TDC is "OC", and the timing mark is "SP"

Eric of the Green Mountains
Attached Images
File Type: jpg IMAG0888.jpg (13.9 KB, 47 views)
Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 09:37 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.

Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.

MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.

This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC

All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.

Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.