Only Cub Cadets

PLEASE PATRONIZE OUR SPONSORS!

CC Specialties R. F. Houtz and Sons Jeff in Pa.

P&K Cub Cadet Machtech Direct

Cub Cadet Parts & Service


If you would like to help maintain this site & enhance it, feel free to donate whatever amount you would like to!




Attention Guest, We have turned off the forum to guest. This is due to bots attacking the site. It is still free to register.

-->
Go Back   Only Cub Cadets > Cub Cadets > IH Cub Cadet Tractors (GT)

Notices

Reply
 
Thread Tools Display Modes
  #1  
Old 02-22-2013, 08:26 PM
Bushman Bushman is offline
Member
 
Join Date: Feb 2012
Location: Michigan
Posts: 33
Default In the land on snow tomorrow , my 1450 is leaking

I just went to my garage to look at my tractors and found a heck of a red puddle under my 1450. Just a passing glance revealed that there was fluid dripping off the disc brake onto the wheel then to the tire leading to the pool on the floor. Does it just go without saying the axle seal failed? Last Saturday I was blowing snow and did see some drips and thought it was related to my exhaust heating up the snow thrower and drips from that deal but, it werent.
Reply With Quote
  #2  
Old 02-22-2013, 08:37 PM
R Bedell R Bedell is offline
Founding Member
 
Join Date: Mar 2007
Location: Michigan
Posts: 13,693
Default

Quote:
Does it just go without saying the axle seal failed?
Sounds like it.
__________________
[B]Roland Bedell[/B]

CC Models: 100, 105, 1450, 782, (2) 784, & 2072

[SIZE="4"][B][COLOR="Red"]Buy:[/COLOR][COLOR="Blue"] Made in the USA[/COLOR][/B] [/SIZE]:American Flag 1:
Reply With Quote
  #3  
Old 02-22-2013, 09:06 PM
sawdustdad's Avatar
sawdustdad sawdustdad is offline
Grand Member
 
Join Date: Dec 2012
Location: USA
Posts: 2,627
Default

Wondering if replacing an axle seal involves removing rear cover, pulling a spring clip off the axle end, pulling the axle out, removing and replacing the seal in the end of the axle carrier, and re-installation of the axle. Is there any reason to pull the axle carrier off the center housing? Is it that easy?
__________________
Reply With Quote
  #4  
Old 02-22-2013, 09:13 PM
Bushman Bushman is offline
Member
 
Join Date: Feb 2012
Location: Michigan
Posts: 33
Default

I am on a mission now. Must assume that the seals are the original ones and after the decades they have been holding up their end of the deal its OK in my book to give them their RIP and put some new ones in to do some work. Should this be a common dealer part?
Reply With Quote
  #5  
Old 02-22-2013, 09:17 PM
Bushman Bushman is offline
Member
 
Join Date: Feb 2012
Location: Michigan
Posts: 33
Default

I have been moving some snow with the blower recently without chains on the tires. Yeah, the tires have been spinning alot in subzero weather. Guess its time to do some bonding with an IH product.
Reply With Quote
  #6  
Old 02-23-2013, 01:09 AM
Yosemite Sam Yosemite Sam is offline
Grand Member
 
Join Date: Mar 2009
Location: Medora, IL
Posts: 3,866
Default

Sometimes the axle bearing will wear out and that in turn will cause the seal to fail.
__________________
More IH Cub Cadet Parts RIGHT HERE
Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 09:47 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.

Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.

MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.

This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC

All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.

Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.