Only Cub Cadets

PLEASE PATRONIZE OUR SPONSORS!

CC Specialties R. F. Houtz and Sons Jeff in Pa.

P&K Cub Cadet Machtech Direct

Cub Cadet Parts & Service


If you would like to help maintain this site & enhance it, feel free to donate whatever amount you would like to!




Attention Guest, We have turned off the forum to guest. This is due to bots attacking the site. It is still free to register.

-->
Go Back   Only Cub Cadets > Cub Cadets > IH Cub Cadet Tractors (GT)

Notices

Reply
 
Thread Tools Display Modes
  #1  
Old 11-21-2009, 08:55 PM
Rhoderman's Avatar
Rhoderman Rhoderman is offline
Senior Member
 
Join Date: Sep 2009
Location: CO
Posts: 235
Default Throttle lever creeps

I have a creepy throttle lever on my 126. It will slowly creep from idle to half throttle in a few minutes.

Are there any easy remedies? How hard is it to pull the lever from under the dash? I haven't looked at it too close, only from above through the slot.

Thanks!

Jim
Reply With Quote
  #2  
Old 11-21-2009, 09:34 PM
mstetar's Avatar
mstetar mstetar is offline
Senior Member
 
Join Date: Oct 2009
Location: Burgettstown PA
Posts: 117
Default

look under the dash, theres is a nut that looks like it holds the throttle lever on to the throttle bracket, and it does but if you tighten it up the throttle gets stiffer!:biggrin2.gif:
__________________
check out my cub site
Reply With Quote
  #3  
Old 11-21-2009, 10:36 PM
Rhoderman's Avatar
Rhoderman Rhoderman is offline
Senior Member
 
Join Date: Sep 2009
Location: CO
Posts: 235
Default

I think I saw that. Looked like a bolt. I was thinking it was a shoulder bolt, and I was needing a stiffer wavy washer or something.

I'll take a look at it and give it a turn with a wrench.

Thanks!

BTW - I saw your mishap w/ the front axle. Ouch!
Reply With Quote
  #4  
Old 11-21-2009, 10:59 PM
Yosemite Sam Yosemite Sam is offline
Grand Member
 
Join Date: Mar 2009
Location: Medora, IL
Posts: 3,866
Default

If the cable feels loose then try what mstetar says.

If the cable is hard to move then the cable itself could be corroded, might try to spray it down with PB Blaster and work it back and forth.
Reply With Quote
  #5  
Old 11-22-2009, 12:37 AM
Rhoderman's Avatar
Rhoderman Rhoderman is offline
Senior Member
 
Join Date: Sep 2009
Location: CO
Posts: 235
Default

Much better now! Thanks Mstetar.
I didn't realize it was a bolt through, with a self-locking nut on the back side. Just a bit tighter and it feels just right.
No more runaways when it should be idling...
I appreciate the help!
Jim
Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 04:01 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.

Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.

MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.

This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC

All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.

Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.