Need to add electric fuel pump to puller

[counciltucky]

I have a 108 puller with a 14 hp kohler it does ok but I would like to add electric fuel pump. Is there anyone who can help me get started with info and what to do?
Thanks for any info?

[Sam Mac]

You may want to look at something like this
http://www.summitracing.com/search/?...fs-10701&dds=1

for a pump. You should just need to wire it to the ignition switch for power and run a hose from the tank to a filter then to to the pump and from the pump to the carb. Make sure you don't get a pump with too high of an output pressure or it may over power your float in the carb and flood the engine.

[counciltucky]

THANKS SAM
THAT LOOKS LIKE JUST WHAT I WANT , NOW HOW MUCH PRESSURE SHOULD I NEED? 4 TO 7 ? DO I NEED TO PUT A REGULATOR ON IT? OR WILL THE NEEDLE AND SEAT CONTROL IT?

[pvolner]

I run a low pressure Facet that I got from Napa on my 2072.
I think it's a 4psi

[Sam Mac]

Originally Posted by counciltucky

THANKS SAM
THAT LOOKS LIKE JUST WHAT I WANT , NOW HOW MUCH PRESSURE SHOULD I NEED? 4 TO 7 ? DO I NEED TO PUT A REGULATOR ON IT? OR WILL THE NEEDLE AND SEAT CONTROL IT?

The pump in the link is a 4 PSI pump. Keep in mind the older tractors had a gravity feed from the tank so they don't need much pressure.

[jmroy]

Check out the one Kirk Engines has http://www.kirkengines.com/