|
PLEASE PATRONIZE OUR SPONSORS!
|
|||||||
 |
|
|
Thread Tools
|
Display Modes
|
|
#1
05-31-2012, 12:36 PM
|
|||
|
|||
Electric PTO Install help
I recently picked up a 1250 that was half taken a part. I am in the process of putting it back together and I am having a bit of trouble with the Electric PTO. I have never worked on one before (First wide frame in my fleet). When I tighten the adjusting nuts and measure the gap I cannot get it down to .01”. It is at .03". If I continue to tighten the adjusting nuts, the plate comes in contact with the disk that is connected to the pulley. I will try to get some pictures next time I’m over at the shop. I have the service manual and I believe I have followed everything correctly. Maybe I do not have the bolt on the end of crank tight enough. How many ft lbs does this bolt take?
Thanks Chris 
|
|
#2
05-31-2012, 12:48 PM
|
||||
|
||||
|
Sounds like you are missing some installation shims. Here is the service manual. Check section 2-81C for assembly directions.
http://ccmanuals.info/pdf/1x8-9%20&%...e%20Manual.pdf
__________________
DWayne 1973: 128, ag tires, 3pt. lift, spring assist, lights, 42" Deck 10" moldboard plow 2016 XT1 42" deck 18HP
|
|
#3
05-31-2012, 01:01 PM
|
|||
|
|||
|
Thanks for the quick reply. I've been through the manual and I can't figure this out. The PTO came off of a running engine and the Driving Hub and Driving disk were already together. I have not taken them a part. I put the field coil on the block, installed the studs. Then I put the Driving Hub and Driving Disk assembly on the crank. Where are the shims that you are referring to? Between the Driving Hub and disk?
I think I have this figured out, the last plate that the adjusting nuts move is the brake disk. Is supposed to come in contact with the driving disk? If so, I should continue to tighten the adjusting nuts until it pushing the driving disk to .01" from the hub.
|
|
#4
05-31-2012, 01:48 PM
|
|||
|
|||
|
|
|
|
|
Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.
MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.
This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC
All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.
Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.
Linear Mode
