Wiring harness connectors Cub 1450
 

I purchased a new wiring harness for my 1450, I will be needing the connectors on the engine/tractor side. Can anyone point me in a direction to get the connectors, I don't have any pictures or anything to go by, so if someone could snap some pictures of a 1450 wiring harness I have found the wiring diagram, however I think I need a connector/pigtail from the voltage regulator to the wiring harness, or something. I'm going to post a pictures of the wiring harness I purchased, along side the one I took off below. I have a 3 pin connector one the old one, and do not have a 3 pin on the new one, however it may have an extra connector. Just wondering if anyone has a source for the connectors.

http://img.photobucket.com/albums/v4...harness004.jpg

http://img.photobucket.com/albums/v4...harness003.jpg

Hi Clint
I hope I have this right but if not maybe Roland will point out my mistakes.

Quietline Wiring Harness







Red - Ignition wire (Green wire –Amp Gauge Negative post)


Upper Black - PTO switch

Lower Black 2 Hour Meter (White Wire - Starter Solenoid)

Green – Stator & Positive Terminal of Coil

Orange – Safety switch

Blue - Fuse

Sorry for the last post here is the picture that didn't post Red - Ignition wire (Green wire –Amp Gauge Negative post)


Upper Black - PTO switch

Lower Black 2 Hour Meter (White Wire - Starter Solenoid)

Green – Stator & Positive Terminal of Coil

Orange – Safety switch

Blue - Fuse