Xtreme front wheel brackets
 

Welding on a pair of Xtreme's front wheel brackets. Does any one have the correct measurements pertaining to where these go in relation to the rear wheel brackets?

i just did this with some that i cut off an old gt deck... got the updated spindles to put in my 50a and the front wheel brackets...real cheap...anyways, i just held a piece of angle against the flats of the rear brackets, held it square, lined the fronts up the same, and 90 degrees from ground..thats where they were on the deck i cut them off of...understand?? basically in line with rears

Yeah, that's what I was thinking but on my gt 46" deck the fronts are set in more than the back. Classic case of over thinking. Thank you!

no problem bud...deck looks nice..is that for the 1450?? cant wait to get mine done

Yep, in line with the rears. I had a scrap 44A that had them on it. I cut them off and put them on my 50A that I refurbed