Cub Cadet 70 help
 

I'm trying to remove the grill and removed 4 bolts. It's loose but wont come out. It rocks back and forth, but something is holding it in. Any ideas ?? thanks

Do you still have the mower deck mule drive on?The front bolts on either side have to be removed.

"you must unlearn what you have learned"

"learn from the master you must"


Seriously though good luck with your project. Have any pics?

The pto lever must be removed?:bigthink:

Are you trying to take the grill out, or are you trying to take the grill shell off?

think i got it . i didnt see the side bolts in the front, took them out and bang off it came. Then another newbie mistake, trying to get the engine out i took off the 4 bolts from the top, engine was loose, but it would not come out and split at the bottom. I didnt see the bolts coming through the bottom into the lower part of the engine which holds it to the from. Uncle ( esarvey) should of been there for this. I wil post pics when the new engine is in place. thanks everyone

Glad to hear you got it! Thanks for the update!

X2! :beerchug:

Live & learn
 

:BangPC: Remember GRASSHOPER , U are the one who shoehorned an LT1 into a RX-7 body , U will not fail in this engine swap , SLOW and think it through , as Ole -unc is with U all the way !!!:beatdeadhorse: