![]() |
105 Hood and Pivot repair?
The hood on my 105 has the pivot holes torn out. There are just long standard bolts in the pivot holes. Any recommendation or pictures for this repair?
|
I normally cut out the rusted area and replace with new metal. Drill a new hole then weld a washer on the backside. There really isn't any other way to repair to torn out area.
|
That's pretty much all you can do.
|
Can I buy the original grommets or bushings that were used?
|
They originally had a very thick "washer" welded on the inner part of the hood. If you really take your time you can probably duplicate the way it was. I think all of the tractors that I own, that have been repaired, are pretty sloppy.
You may be just as well off to find a good used hood. |
All times are GMT -4. The time now is 05:55 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.