forward,reverse lever questions
 

Tractor is a 107 1970





2nd question. My forward and reverse lever on the dash moves kinda easy. So when it's moving the lever moves kinda easy also. SO I need to hold it still while holding it and the steering wheel. I looked underneath the tractor and seen a bit of linkage but not sure what needs replaced and or tightend up. I assume the lever should move to easy.



Here is a video
http://youtu.be/HtYJNIBkGa0

That is a Mule Drive Extension Spring

Get it from your local Cub dealer or contact our sponsors up at the top of the page, or place a want add here on the site.

Part Number: IH-489607-R4 Price $6.44

Thanks will defy hit them up on that. That takes care if first question :)

The tension adjustment for the Hydro Handle is in the Service Manual as found in our Technical Library Section.

Thanks very much. Please don't feel like
I don't search. Just bit harder on a phone. Plus I have no idea what the smaller parts are called. This is my first tractor :)

The service manual def. will help. There is a nut inside the dash that needs to be tightened to make the hydro lever not flop like it is. Good luck.

An open end wrench, 1 1/16, cut to about 3 inches, will help you tighten the lever tension nut.

Ok thanks for info.
I found the pdf i needed.

I looked for the nut, but i dont see it.
Everything from the lever down is tight no play.
It seems to be in this area in the red circle

http://i681.photobucket.com/albums/v...v/newlever.jpg

Ok I found this hidden adjustment nut lol.
Need to get to it now

Ok trying to remove the steering wheel, and the speed control lever.

I have the nut of the wheel abut wont budge.
The lever I have the screw backed all the way out but wont budge,