Headlight Harness
 

Can someone post a pic up of a headlight harness on a 73 / 127.

I need to make one and wanted to see an original one so I can duplicate it.

This should help you.... Diagram. Scroll down to the 1x6/7 Series.

Thanks
 

Thanks I have that but looking for a picture of the actual harness so I can duplicate it to factory look. The wire that were on there were put together with wire nuts!!!! Yikes.

First, let me say, that I do not own a model within the 1x6/7 series of Cubs. Based upon what I have seen on other series of Cubs, I would venture an educated guess, that there is no "headlight harness". I suspect, that there is a single 14GA Yellow Wire that connects to each end of the Main Harness at the purple wire connectors, as it travels through the "tunnel" area..

I would simply get some 14MTW GA wire in Yellow and a few terminal connectors, an inline fuse holder, a light switch, and wire up as indicated in the Wiring Diagram.

Now, it is not to say, that one can not find the actual wire that IH made for their lighting kit but I would guess this maybe a tad difficult.

One could try the Sponsors above and place a Want Ad in the Classified Section to see if any can be found.

I'd go with Roland on this one.... The light harness I got for my 127 was as described by him. I've saw a few more harness pictures looking on flickr and they are all the same way.

Since this post is related to lights, where does one BUY the rubber type cushion for the lights? Can't seem to find them?

I took my headlights out to replace them & the rubber gasket that
I'm assuming it's to absorb vibration, & it fell apart in itty bitty pieces of garbage.

Any suggestions if those gaskets aren't available?

I would think that they are IMPORTANT?

Thanks in advance,

Nik,

Picture
 

Picture Gary!!!! Please!!!

Nik:

I would look at your Ag or Farm Implement Stores and/or Suppliers (ie: TSC).

Here's a couple pics from my 147, same as 73, 127 I think. Hope this helps ya out.

These are the only ones on my laptop... let me know if you need other angles and I'll snap some later.

Wires
 

Hey JaysNJcub127
If you can give me a day I can post pictures of an actual headlight harness from one. I make the harnesses from the original factory wiring dimensions and have a few of the old ones at home. I can post pictures as well at measured lengths of the wires for you. On the headlight wiring I use 12 ga. yellow wire. The ground terminal for the voltage regulator bracket bolt is a 1/4" ring terminal.

Ah, called Farm & Fleet & the gal told me I can get them.
Thanks,
Nik

Photo
 

The hot wire that runs from bulb to bulb is 13" from terminal tip to terminal tip. The ground has two wires about 8 1/2" each in length.

ThIs is just what i am looking for thanks guys i just bought two head lights today and i was wondering how to wire it up.