100 PTO Engage Lever
 

I recently picked up a Cub 100 and it is missing the pto engage lever. I can find parts diagrams and the parts but how does it go together? Could someone post a picture or a sketch of how the parts go together on the tractor?

Is this what you are looking for...??

I have found that but I am looking for what hardware mounts the lever to the tractor. How does that all go together with the spring, spacer, what bolt is used?

Here is the hardware for items 4 & 7....

That helps out some. Does anyone have a picture of the assembly mounted on the console of their tractor? I'm still confused as to how the spring works in the assembly.

This might help. A picture of my 70(same engagement lever) it has a 3/8 bolt,then washer then lever then spring then goes through the tower and a lock washer and lock nut. I might have better pictures. I think there was a spacer but dont remember.

That helps clear it up a bit. If you have any close up pictures from side angles so I could see what it looks like from drivers seat that would help too.

Here is the one from my nephews 73, hope this helps.

http://i210.photobucket.com/albums/b...3/DSC02685.jpg

http://i210.photobucket.com/albums/b...3/DSC02686.jpg

http://i210.photobucket.com/albums/b...3/DSC02687.jpg

http://i210.photobucket.com/albums/b...3/DSC02688.jpg

http://i210.photobucket.com/albums/b...3/DSC02689.jpg

Here's the only rear view I have.

Mike!!
I could comment on that statement butt.....
Here is mine.
There is a spacer in the hole on the handle that keeps it loose.

http://i899.photobucket.com/albums/a...lePics1375.jpg

http://i899.photobucket.com/albums/a...lePics1376.jpg

That's exactly what I was looking for. I'm missing the spacer and was going to make it but wasn't sure where it went or what diameter it needed to be. THANKS!