Only Cub Cadets - 1450 Lift Valve Handle Removal- Suggestions??

Only Cub Cadets (https://www.onlycubcadets.net/forum/index.php)

- IH Cub Cadet Tractors (GT) (https://www.onlycubcadets.net/forum/forumdisplay.php?f=9)

- - 1450 Lift Valve Handle Removal- Suggestions?? (https://www.onlycubcadets.net/forum/showthread.php?t=48666)

Quote:

Originally Posted by TOPDOWNRESTO (Post 421991)

Also and lastly for my 1650 I could use the measurements for the placement of front hydro outlet holes as I will need to do that . I have access inside or out as engine and cradle are out still.

thanks for your help

Carroll

I'll get that for you next week when I return home.

Here's the measurements to locate the front holes for the hydraulic ports. I'm just okay at measuring and even worse at drawing so....

Got it, thanks Gary !

Quote:

Originally Posted by gsomersjr (Post 421770)

The handle I have is broken so I'm adding both pieces to get the total measurement. I've attached a pic of an unbroken handle also.

The center smooth section is 4 11/16 long, .40 OD
The good end has 1" of 3/8-16 threads
The broken end has (approx.) 1.75" of 3/8-16 threads
Total length is 7.5" including the machined tip that acts as a lock on the horizontal shaft.

I'm not a machinist so these measurements are just "pretty close"

I corrected the thread size in your reply. Please go back in your reply and change them from 24 threads per inch to 16 threads per inch.

I have to make another shaft