PLEASE PATRONIZE OUR SPONSORS!
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
6-12s on a QL
I put the 6-12s on my 1250, and of course, only after I put them on did I notice the one is literally bursting at the seams. Not overfilled, just ran flat and falling apart. I don't know what kind of tractor they came off of, but they're white with the 5 bolt cub rims.
I'll be on the lookout to find a set of nice ones, I guess. What kind of 6-12s do you guys use on your tractors? I would be fine with either turfs or ags. |
#2
|
||||
|
||||
6-12's are to small for that tractor, you want 23x8.50-12 or 23x10.50-12. since your budget is limited I would look at deestone tires, they are nice and fairly cheap.
__________________
Tim Pap's 100 Restored 108 1211 Dual Stick 1050 Pap's 100 restoration thread - http://onlycubcadets.net/forum/showthread.php?t=47965 |
#3
|
|||
|
|||
What do you mean by "too small?" If it's about the look, oh well. If it's about the weight limit of these tires, you're kind of right, the tires don't seem like they'll hold a lot of weight like they are.
|
#4
|
||||
|
||||
That tractor came from the factory with 23x8.50's with the option for 23x10.50's. you asked about buying new tires and I'm not sure why you would want to buy the wrong size when you can buy the correct size for a few bucks more. You will never get enough weight on those back tires for it to be an issue unless you're doing something stupid and dangerous.
__________________
Tim Pap's 100 Restored 108 1211 Dual Stick 1050 Pap's 100 restoration thread - http://onlycubcadets.net/forum/showthread.php?t=47965 |
#5
|
|||
|
|||
The 6-12 tire size was used on the CCO, 70, 71, and 100. Starting in the 1x2/3, IH started using the 23x8.50-12 as the smallest size.
It is your tractor, your time, and your money. You can do as you see fit.
__________________
Roland Bedell CC Models: 100, 105, 1450, 782, (2) 784, & 2072 Buy: Made in the USA |
#6
|
||||
|
||||
That size, with that tread, with chains would be great for a snowplowing or throwing tractor.
More psi on the ground than with the wider tires. |
#7
|
|||
|
|||
Quote:
|
#8
|
||||
|
||||
Parts book shows 6-12 tires were available for the 800 I had a set on mine, they were turf tires.
__________________
Up to 530 and counting... I give up updating my profile! |
#9
|
|||
|
|||
You can run 6-12's if you want. I do it on my tractors. Just because it didn't come offered with them does not mean they don't fit and work well. Not a damn thing wrong with it. I prefer 6-12's for plowing because they fit in the dead furrow best. If you are going to run them, I suggest AG's, but the style you have on it now work well too. I have plowed with both the "knobby" style turf's and the AG's.
FWIW, the 6-12's do not make good tires for snow work. The larger tires weighted with chains do better. You say you need room to maneuver.... even the 12" wide tires don't stick out any farther than the front blade, or the mower deck. Plus, if you look, I think you will find with the 6-12's the front tires stick out farther..... I can't imagine you need that you are gaining much maneuvering room. |
#10
|
|||
|
|||
Quote:
If my plan works, I'll have a set of good 6-12 buzzsaw tires. My plan is to take a weighted wheel with a junk rim and swap it to the 6-12 rim that's on the tractor (left tire in picture), as the tire on the rim is exploding apart-luckily the tube holds air. Hopefully, the weighted tire won't be shredded from the concrete inside it and I'll be able to break the exploded tire off the rim without shredding the tube inside, so I can have a good set of 6-12s. |
Thread Tools | |
Display Modes | |
|
|
Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.
MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.
This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC
All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.
Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.