PLEASE PATRONIZE OUR SPONSORS!
|
|
Thread Tools | Display Modes |
#11
|
||||
|
||||
OK
__________________
2264 with 54 GT deck 1641 AKA Black Jack with a 402-E Haban Sickle bar mower JD317 dump truck BX2670 with FEL |
#12
|
||||
|
||||
X2 he is talking about the subframe. That way when you whack something hard under the snow that ya don't see you'll feel it throughout the whole tractor centering under your feet where the rockshaft is. Another thing to remember is to keep the blade unlocked so it can trip if and when that happens.
__________________
Daniel G. . (May 1970) 147 w/an IH spring assist, 48" deck, 42" blade, 1969 73, #2 trailer, 10" Brinly plow and (on loan) Dad's #2 tiller. |
#13
|
|||
|
|||
Quote:
Concur on the unlocked position of the blade. |
#14
|
||||
|
||||
I have ended up on the hood of my (modified, many times) 72.
It is truly true, don't forget to unlock the blade release. |
#15
|
|||
|
|||
Update
Well, we finally had enough snow to push on Wednesday of this week. The 782 did great on downhill and level areas, no so much on uphill areas when a big snow was being pushed. All that without chains. Was hoping the super aggressive tire tread would be good enough to not install the chains.
Had a neighbor call last night wanting her driveway pushed. So went out early this morning (10 deg F) and installed chains. Opened the gas valve, pulled the choke and it fired up on the 3rd try. I erroneously pushed in the choke too early and it died. After that, all I could get was a clicking sound from the solenoid. Sounded like battery was too low, but it wasn't. Put a jump on it and still clicking. Think the solenoid is stuck or bad. Had to call my neighbor and apologize for not being able to get it done. The hydraulically actuated blade worked great though. Will get this thing running again and just put chains on in early winter to stay on all winter. |
#16
|
|||
|
|||
Quote:
__________________
Roland Bedell CC Models: 100, 105, 1450, 782, (2) 784, & 2072 Buy: Made in the USA |
#17
|
|||
|
|||
Ditto on the connections, same thing happened with my 1872. I put a charger on the battery and it wouldn't pull any amps, the battery was full charged, the terminals were loose, it was starting good until I really needed it. I had just purchased mine also. Easy fix.
|
#18
|
|||
|
|||
Good suggestion, Roland. I'll get back out there when the temps are a little warmer and check 'em out. Will let you know...
|
#19
|
|||
|
|||
Checked all the electrical connections (including grounds) and made sure they were clean and bright. No issues there.
Each time I turned the key to the start position, I could hear the solenoid click and then a high pitched whine. I ordered a new solenoid anyway, just to eliminate that as a possibility. If that's not the culprit, then I can put the old solenoid back on and look somewhere else. Will keep you posted. New solenoid is to be delivered on Thursday. Thanks. |
#20
|
||||
|
||||
I thought the same, until I saw the OP was in MO
__________________
Why Farm Half When You Can Farmall? 1282 | 44C Deck, Chains, 42" Blade, Cast Weights, 020" Over K301 * 1711 | 50C Deck, #1 Rear Rototiller w/ Extensions, Sleeve Hitch, KT17S Series II 24302 --> CH18S * 1811 | 46 GT Deck, 42" Blade, Chains, M18 Magnum, Sleeve Hitch * 1782 | 60" #375 Deck, Kubota D640 Diesel * 1862 | #450 Snowblower, M18 Magnum * 782 | Y/W KT17 Series II, Sleeve Hitch * 984 | Y/W Onan/Linamar 20HP, Sims Cab, CAT 0 3 PT w/ Rear PTO, 60" #374 Deck |
|
|
Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.
MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.
This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC
All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.
Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.