Only Cub Cadets

PLEASE PATRONIZE OUR SPONSORS!

CC Specialties R. F. Houtz and Sons Jeff in Pa.

Cub Cadet Parts & Service


If you would like to help maintain this site & enhance it, feel free to donate whatever amount you would like to!




Attention Folks we have a new owner!
Greg Rozar AKA- CubDieselFan


Go Back   Only Cub Cadets > Cub Cadets > IH Cub Cadet Tractors (GT)

Notices

Reply
 
Thread Tools Display Modes
  #1  
Old 08-07-2011, 10:48 PM
mr.ridout mr.ridout is offline
New Member
 
Join Date: Aug 2011
Location: Texas
Posts: 3
Default Clutch repair

I have a 128 with a stuck clutch. The repair info I have indicates that the engine must be unbolted and moved to remove and fix the clutch. Is this the case? And the picture shows a coupler disc just ahead of the transmission. Mine doesn't have one, just a short metal tubular connector with a pin through it. Does it need one.

Mick
Reply With Quote
  #2  
Old 08-07-2011, 11:07 PM
_DX3_'s Avatar
_DX3_ _DX3_ is offline
Grand Member
 
Join Date: Jun 2010
Location: Richmond, Kentucky
Posts: 5,798
Default

Pics would help a bit of this coupler. As for engine removal, you can try moving the engine forward, but if you have the deep sump oil pan you will probably need to remove the engine to access the clutch.
__________________
DWayne

1973: 128, ag tires, 3pt. lift, spring assist, lights, 42" Deck

10" moldboard plow

2016 XT1 42" deck 18HP
Reply With Quote
  #3  
Old 08-08-2011, 06:52 AM
Matt G.'s Avatar
Matt G. Matt G. is offline
Senior Member
 
Join Date: Mar 2009
Location: Wichita, KS
Posts: 5,661
Default

The rubber coupler is used on the next series up. Your tractor should have a solid coupler.

If the tractor has been sitting, that's pr obably why the clutch is stuck, and you can just slide a putty knife in between the pressure plates and friction disc to free it up.
Reply With Quote
  #4  
Old 08-08-2011, 07:58 AM
mmzullo mmzullo is offline
Senior Member
 
Join Date: Dec 2009
Location: Kinnelon,NJ
Posts: 550
Default

When you mean stuck clutch is the disc stuck to the flywheels? If so I've had good luck with locking the pedal down and tapping on the disc a little and somtimes they pop. You can also get a small screw driver and wedge it in between the disc and flywheel. Be careful sometinmes the disc get brittle. You can use a penitration oil. DONT USE PB( TOO OILY) IT"S TOO GOOD FOR THE CLTUCH. Use wd 40 it washes away. just start spraying and working it. It should pop.when it does just wash every thing with brake cleaner. I've also done this with good results.
Good luck.
Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 11:21 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.

Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.

MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.

This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC

All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.

Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.