|
PLEASE PATRONIZE OUR SPONSORS!
|
#1
01-30-2016, 12:33 PM
|
||||
|
||||
Mini Super
Building a Mini Super from a 782D.IH frame MTD frame was junk,Super Cat-O 3 point turn brakes super front axle,power steering Turboed D600
|
|
#2
01-30-2016, 12:41 PM
|
||||
|
||||
|
Looks good, one thing I'd like to point out is that the dual brakes will hit the side panels on that short frame. (At least that's what I've been told by members on this forum when I wanted to put them on my 1811)
__________________
Tim Pap's 100 Restored 108 1211 Dual Stick 1050 Pap's 100 restoration thread - http://onlycubcadets.net/forum/showthread.php?t=47965
|
|
#4
01-30-2016, 01:37 PM
|
||||
|
||||
|
I think the pedals will be ok the lift arm has to be cut about an inch so pedal doesn't hit
|
|
#7
01-30-2016, 09:46 PM
|
|||
|
|||
|
Quote:
|
|
#8
02-01-2016, 11:06 PM
|
||||
|
||||
|
Looks like a page out of Nightow1 s book on his 782.
 I hope your going to hook up the rear pto! Otherwise a 3pt, pwr steering, turning brakes and big tires isnt anything that has not been done to a gt before, by just about everyone... On another note, your paint job looks very nice and it looks like a clean project. If you keep the good work going it will look sharp
__________________
1- 1864 Dual hyd, cat 0, axle braces 1- 1450 Dual Stick w/ power steering 1- 1200 in pieces 1- 1864 in pieces QA36A Thrower, #1 Tiller w/ extensions, IH windbreaker, IH wheel weights, 44C mower deck, 50C mower deck, CCC 54" Blade, GT46 high vacuum deck, GT54 deck, Cub Tripple Bagger, Custom dozer blade, Custom suitcase weights, 3pt cultivator, lawn sweeper, original R-Bucket
|
|
#9
02-02-2016, 06:18 PM
|
||||
|
||||
|
turn brakes
The turn brakes are close to the side panel but will work need to trim off the lift arm about an inch and the fenders will be blocked up an inch.Looking for a rear PTO but haven't found one yet.
|
|
#10
02-02-2016, 06:53 PM
|
||||
|
||||
|
Unfortunately your lift arm will be useless because of the turning brake. Might try to sell the one you have before you cut it then look for the super style lift arm.
The pto will be expensive, but it will complete your build. Did you retain the gt hydro pump or did you put a super hydro pump or 1864 sunstrand on? This is important in the fact it has the rear splines vs the small shaft with the pin hole. Just suggestions. Trent
__________________
1- 1864 Dual hyd, cat 0, axle braces 1- 1450 Dual Stick w/ power steering 1- 1200 in pieces 1- 1864 in pieces QA36A Thrower, #1 Tiller w/ extensions, IH windbreaker, IH wheel weights, 44C mower deck, 50C mower deck, CCC 54" Blade, GT46 high vacuum deck, GT54 deck, Cub Tripple Bagger, Custom dozer blade, Custom suitcase weights, 3pt cultivator, lawn sweeper, original R-Bucket
|
 |
|
|
Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.
MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.
This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC
All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.
Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.
Linear Mode
