Only Cub Cadets

PLEASE PATRONIZE OUR SPONSORS!

CC Speciaalties R. F. Houtz and Sons

Patton Acres IH Cub Cadet Parts

Cub Cadet Parts & Service


If you would like to help maintain this site & enhance it, feel free to donate whatever amount you would like to!




Attention Folks we have a new owner!
Greg Rozar AKA- CubDieselFan


Go Back   Only Cub Cadets > Cub Cadets > IH Cub Cadet Tractors (GT)

Notices

Reply
 
Thread Tools Display Modes
  #1  
Old 01-14-2019, 11:25 AM
Misch1450 Misch1450 is offline
New Member
 
Join Date: Jan 2019
Location: Indiana
Posts: 1
Default Hydraulic question

I have a 1450 with dual hydraulics that I have snow blower attachment. It recently began to leak hydraulic oil and will not fully lower the snow blower. I believe it is the main assembly. In beginning to look at parts, I found the the dual assembly is expensive compared to the single. Question: Can I make the switch to a single assembly with using the same fitting and hoses? Then just remove the second line. Thanks for any help or insight.
Reply With Quote
  #2  
Old 01-14-2019, 11:29 AM
cooperino's Avatar
cooperino cooperino is offline
Grand Member
 
Join Date: Dec 2015
Location: New York
Posts: 3,065
Default

First off welcome to OCC!

So if I am understanding you correctly, You have a double acting cylinder, "power up and power down" and you want to put a single acting cylinder in place of it? Power up and gravity down?
__________________
Cooperino 100, 104,125, 126, 2x129's, 804, 1211, 1641
Reply With Quote
  #3  
Old 01-14-2019, 01:26 PM
CADplans's Avatar
CADplans CADplans is offline
Grand Member
 
Join Date: Oct 2011
Location: VA
Posts: 3,502
Default

Hey Misch,, make sure the hydraulic connectors are FULLY plugged in,,,
if the connector is partly out, the attachment will not go down,,,
Reply With Quote
  #4  
Old 01-15-2019, 10:53 AM
finsruskw finsruskw is offline
Grand Member
 
Join Date: Mar 2013
Location: Iowa
Posts: 2,983
Default

The front outlets have nothing to do with raising and lowering the thrower.
It is controlled with the same lever that lifts the deck when it's installed.

Are you sure the depth stop, the thing with the black knob on the right side of the frame by your foot, is not keeping the unit from fully lowering.? Best bet is to remove that stop for use w/a thrower as it needs to be on the ground fully, all the time.

Also make sure the lockout pin, that is IF you have one, IS NOT in place as it will not allow the unit to "float"
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 07:25 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.

Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.

MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.

This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC

All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.

Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.