|
PLEASE PATRONIZE OUR SPONSORS!
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
#1
08-05-2018, 06:16 PM
|
||||
|
||||
Installed rear axle braces
Well I took everyones advice and got the rear axle reinforcements for the 2072. No instructions came with them but its pretty straight forward so I just took the weight off the rear end and bolted everything up. Refilled fluid and now I have a leak at the axle tubes. I installed the thin washers on the outside of the braces, should they be between the brace and the tube? Or am i forgetting/missing something else?
If I'm taking it apart again I want to do it right this time because refilling is annoying and time consuming. 
|
|
#2
08-05-2018, 08:56 PM
|
|||
|
|||
|
I think you need thread sealant on the bolts so it wont weep out.
__________________
1782, 1862, 1440(sold), 89 1050, 128, 70, some run some don't! 72 scout IH 404 tractor
|
|
#3
08-05-2018, 09:56 PM
|
||||
|
||||
|
I just installed a set on a 1772, I put the washer under the head of the bolt and used little silicone sealant on the threads. No problems.
__________________
149, 2072, Original, 1772, 1782, #1 cart, Parker 48" sweeper,
|
|
#5
08-06-2018, 06:33 AM
|
||||
|
||||
|
You can use a vacuum cleaner hooked up to the dipstick tube when you pull the bolts out. The suction will keep the oil from running out of the bolt holes. I use Permatex # 3 on the bolt threads. Clean the threads first with some brake clean.
__________________
2264 with 54 GT deck 1641 AKA Black Jack with a 402-E Haban Sickle bar mower JD317 dump truck BX2670 with FEL
|
|
#6
08-06-2018, 09:28 PM
|
||||
|
||||
|
Quote:
|
|
#7
08-08-2018, 01:38 PM
|
||||
|
||||
|
Quote:
__________________
1912 with Kohler M18 engine repower, CI rear, 50C deck, 364 snow blower IH Cub Original with deck #2 cart GREEN 314 with integral sleeve hitch, H2 and independent brake upgrade from a 317, and front hydraulic blade, 48" deck
|
|
#8
08-08-2018, 05:35 PM
|
||||
|
||||
|
Yep, I use an old vacuum pump for HVAC work to suspend the oil in the rear when replacing a leaking bolt. I use Permatex #2 and torque to 30 ft/lbs. Just make sure the area is clean so you don't suck any junk into the hole.
__________________
This ain't no hobby....it's an addiction
|
|
#10
10-26-2021, 10:02 PM
|
||||
|
||||
|
I have Diesel Doctors 1772 and it has a 3 point. I will look at it closer and shoot some pictures.
__________________
1572, 1864 x2, 1810 x2, 1863 & GT1554(Dad's Ole Mowers), 1811,782D, 1872 x2, 782DT(Sold), 3235, 1860, 1772 with 3-point and Turbo.
|
|
| Thread Tools | |
| Display Modes | |
|
|
Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.
MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.
This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC
All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.
Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.
Linear Mode
