PLEASE PATRONIZE OUR SPONSORS!
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
So this was a weird string of events .....
Puttering on my 1872. I replacing worn out parts , cleaning , etc. I just got the front axle back in, all new rod ends. I wanted to move the tractor ahead in the shop. I turned key, it started, ran about 5 sec. and stalled. OK, not a big deal. Oh snit , I cleaned the gas tank , and didn't refill. Well maybe there is enough fuel in the carb bowl to move it the 20 feet I need. Turn the key again - NOTHING , NOPE , NADA , Dead ! What tha ???
Check battery connections, turn key again, lights come on bright, oil light is good, NOTHING DEAD ! Maybe blew the fuse ? I grab the fuse holder cap, twist and pull, the whole fuse holder pull out. It shorts against the dash panel, sparky sparky , and shove it back in. I unhook the battery, disconnect fuse wires, remove, fuse IS blown (well now for sure). There was corrosion and green crud inside. A quick trip to parts store, new fuse holder, and fuses. I install the parts and try again NOTHING - DEAD! I dig out the Test Light, power here, power there, except no power when switch is in "start" position. Whats that all over the back of the ignition switch? Corrosion, green crud .... ARGGGGGGGGG !!!!!!! New switch ordered this morning. Come on Amazon ! |
#2
|
|||
|
|||
YUP, that switch is TOAST.
__________________
Roland Bedell CC Models: 100, 105, 1450, 782, (2) 784, & 2072 Buy: Made in the USA |
#3
|
|||
|
|||
I'd bet the contacts in the harness plug aren't in much better shape either.
|
#4
|
||||
|
||||
Now inspect the switch plug I'll bet a dollar ta a donut that the wire ends in the plug are not in good shape and most holders are melted on the battery terminal
cavity. you can get something like this: Ebay #382231331196 Others here may have more suggestions. Do check that yours is the same one you are purchasing Edit: Finsruskw types faster than me. |
#5
|
|||
|
|||
I thought of the plug being a problem. It actually looks good, no corrosion, just dirty. The corrosion seems to be within the switch itself and the contacts on the rear. I lucked out on missing out on a bunch of little burns, soldering 5 new ends on a new plug, dam it ! Switch is on order, due in next week.
Thanks Guys ! |
#6
|
||||
|
||||
It seems every "new to me" Cadet needs a new switch. Bought a couple packs of the wire ends for the harness---somebody here posted a source (I can't remember now where I bought them, but the info is with my spare parts at the shop).
__________________
2072 w/60" Haban 982 with 3 pt and 60" Haban 1811 with ags and 50C 124 w/hydraulic lift 782 w/mounted sprayer 2284 w/54" mowing deck |
#7
|
|||
|
|||
Quote:
https://www.ebay.com/itm/Ignition-Wi...9F8:rk:12:pf:0 |
#8
|
|||
|
|||
Yes , it is. All the contacts in that plug look good, not corroded , just dirty / grimy. Hit it with the brake clean , looks good . I will use my special nail file converted to spade cleaner and a spooge of dielectric grease upon reassembly.
|
#9
|
|||
|
|||
May not be your problem, but that link for a harness plug is quite useful to me so thanks for the link!
These switches do seem to go bad and corrode. I have started filing them with the anti-oxidation grease used on large electrical connections. Happened to have some from a wiring project - it is very sticky stuff and I squeeze it into the switch through the keyhole. No idea it it helps, but was hoping it might prevent some water from migrating to the inside. |
#10
|
|||
|
|||
THE SAGA CONTINUES
Got the new key switch all installed , the contacts in the plug do look good . set the battery in this morning , hooked all up..... turn key NOPE , NOTHING , DEAD , no lights .....what the ? ? ? ? I actually still have the grill and hood off , shouldn't need the headlights hooked up to run should I ? Doesn't appear so looking at the wiring diagram. The seat switch and the brake switch are both normally open correct , so if I make jumper wires to eliminate them I should complete the circuit correct ? Thanks ! |
|
|
Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.
MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.
This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC
All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.
Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.