PLEASE PATRONIZE OUR SPONSORS!
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Inconsistent cranking on SLT 1554
Over the past few years my cub cadet has become harder and harder to start. Nowadays it has to do with finding the "sweet spot" on pressing the brake and then turning the key. Whenever I hit that sweet spot on the brake it will try to crank but I have to try and hold the pedal at that exact spot until it turns over. But sometimes when I think I've found the sweet spot it tries to crank once and then nothing...or if I lose that spot on the brake pedal it stops trying to crank and I have to start over playing with turning the key and trying to find the sweet spot on the brake again. I was told first to test the brake interlock switch which made a lot of sense after I read what it does... However I took it off today and put it on a millimeter and it seems to work fine, that is 2 sides are always closed and the other 2 sides are closed when the plunger is pushed in... So now I'm at a lost as to where to go to next. Is there anything else that would give me an inconsistent cranking that would appear as if it was my brake pedal? I'm thinking maybe it just seems like the brake has something to do with it but really there is something else further down the startup process?
|
#2
|
||||
|
||||
Sometimes continuity disappears once amperage is applied.
Try jumpering the switch as a test only. I do not recommend permanent use of a jumper especially on a brake safety switch. I suspect that might help you find the problem. |
#3
|
|||
|
|||
Ahh thank you! You learn something new every day. Very useful bit of knowledge for future troubleshooting on other things as well. Googled it as well to get more info on it.
https://electrical-engineering-porta...ing-continuity From the link: Often, a circuit where there is an open circuit fault can register excellent continuity with a low power tester or ohmmeter. But when a voltage is applied, current may not flow. The reason for this is that the circuit may be partially continuous (Example: a partially burnt cable where one or two conductor strands may be making contact) but when feeding a heavy load it will behave as a high impedance. This type of fault will be detected by testing on load using voltage measurements. |
#4
|
|||
|
|||
Quote:
|
#5
|
|||
|
|||
So I installed the new interlock switch but still the same problem. I am charging the battery now just incase it is that but the symptoms are the same in that I have to find the right spot on the pedal to at least get it to attempt to crank and when I do it get it, it might try to crank once, stop, and I need to start over... Before all this started getting worse I used to be able to simply press the pedal turn the key and the thing would continuously tried to crank until it turned over...One thing I did notice was that after a failed crank I hear a hissing sound like something releasing air not sure if that indicates anything...
|
#6
|
||||
|
||||
Please explain your definitions of:
A. "turning over" and B. "cranking" |
#7
|
|||
|
|||
not to sound like a broken record...check your grounds- every one of them including the engine to frame strap and the battery to frame ground! Then clean every plug (and consider Dielectric grease on all of them) including the safeties and the ignition switch. Check connectors held on with bolts/nut verify they are clean and tight. I use anti seize on any single terminal connector. DONT use antisieze on multiterminal connectors it can flow and short/shunt/etc.
|
#8
|
||||
|
||||
Quote:
to me they are the same. Cranking and turning over means the engine it rotated by means other than under it's own power, whether it it turned by a starter, rope or a crank like the vintage vehicles did in wooden wheel days. An engine cranks till it runs on it's own power or the external provided rotation is stopped. Example: it cranked and cranked, till the battery went dead but would not run. OR: I turned the key, but the starter would not turn the engine over, it did nothing Or: I turned the key and the starter ran but it would not crank the engine, I think the starter is defective. OR: I turned the key and it cranked right up, purring like a kitten Clear as mud? |
#9
|
||||
|
||||
Or how about....
I tried to get cozy with my honey, but she was cranky..... so I turned over and went to sleep! |
#10
|
||||
|
||||
Quote:
But I will not derail the train or Roland will get "cranky" And we know what that means. |
Thread Tools | |
Display Modes | |
|
|
Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.
MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.
This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC
All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.
Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.