PLEASE PATRONIZE OUR SPONSORS!
|
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Kohler M18 remote oil filter lines
I probably could do a search of the forum and find my answer, I did a search and found a whole bunch of posts containing "remote oil lines", and I don't have time to read every one of them searching for my answer... so here we go.
Can the remote hoses be replaced separately? I seem to only be finding the whole remote oil filter kits for sale. I had to remove the oil lines to get the side covers off to clean up my engine and they were a bear to get off, now when I put them back on they split (brittle) so I would like to replace just the rubber if I can.
__________________
1912 with Kohler M18 engine repower, CI rear, 50C deck, 364 snow blower IH Cub Original with deck #2 cart GREEN 314 with integral sleeve hitch, H2 and independent brake upgrade from a 317, and front hydraulic blade, 48" deck |
#2
|
|||
|
|||
Short answer: no.
Can you cut the band clamp and replace the rubber with oil rated hose and clamps? Sure, if you trust it will hold. Up to you. Just make sure to get (usually redish/pink) oil rated hose. Fuel line will not work, and heater hose certainly will not. Must be OIL RATED. |
#3
|
||||
|
||||
I see hoses for sale (part number 5232611S) that have threaded fittings on both ends. Mine is threaded on the end to the filter, and slides over a tube on the other end at the engine with a hose clamp. I don't see any way to replace just the rubber, so I guess I'm just looking for the part number for that hose.
__________________
1912 with Kohler M18 engine repower, CI rear, 50C deck, 364 snow blower IH Cub Original with deck #2 cart GREEN 314 with integral sleeve hitch, H2 and independent brake upgrade from a 317, and front hydraulic blade, 48" deck |
#4
|
|||
|
|||
I custom made oil lines for an M-20 four years ago. Worked out well and doing fine.
__________________
Roland Bedell CC Models: 100, 105, 1450, 782, (2) 784, & 2072 Buy: Made in the USA |
#5
|
||||
|
||||
I had lines made for a mag 18 by a local hose shop, they had threaded fittings on both ends.
__________________
Tim Pap's 100 Restored 108 1211 Dual Stick 1050 Pap's 100 restoration thread - http://onlycubcadets.net/forum/showthread.php?t=47965 |
#6
|
||||
|
||||
I took my hose to Napa, and they made me a new one. Wasn't too pricey either...
__________________
Make the best of each day , Todd Original's Face Lift thread.http://www.onlycubcadets.net/forum/s...ad.php?t=34439 (O) Start to Finish video.https://www.youtube.com/watch?v=GAoUNNiLwKs Wheel Around videohttps://www.youtube.com/watch?v=XUL-m6Bramk They can't all be turn key! |
#7
|
||||
|
||||
FWIW:
There are other options for oil filter mountings. There are adapters that bolt to the block, so there are no oil cooler lines to mess with on the kohler engines. I have 4, M-18 engines, 3 of them have the screw on filter on the block. Only one, has remote oil filter lines. The 782's I have, both have the block mounted filter and I use motocrap FL400 filter. There are some who don't like the design as they are a little messy when changing oil, if you don't use a curved trough under the filter to direct the oil into a catch can. ---Different strokes for different folks. |
#8
|
||||
|
||||
I had considered switching to the screw on filter option, but I would need a different engine cover for that to access it.
__________________
1912 with Kohler M18 engine repower, CI rear, 50C deck, 364 snow blower IH Cub Original with deck #2 cart GREEN 314 with integral sleeve hitch, H2 and independent brake upgrade from a 317, and front hydraulic blade, 48" deck |
#9
|
||||
|
||||
I just went to the local NAPA and they don’t make houses but he sent me 1/4 mile up the street to Tennco hose shop (this is what he told me is why he doesn’t do hoses, because there are 3 other places a stonethrow away) and they made two hoses of what I need, they’re blue not red. They’re blue Goodyear flame resistant oil line with shiney new fittings for $32.
__________________
1912 with Kohler M18 engine repower, CI rear, 50C deck, 364 snow blower IH Cub Original with deck #2 cart GREEN 314 with integral sleeve hitch, H2 and independent brake upgrade from a 317, and front hydraulic blade, 48" deck |
#10
|
||||
|
||||
Quote:
__________________
Make the best of each day , Todd Original's Face Lift thread.http://www.onlycubcadets.net/forum/s...ad.php?t=34439 (O) Start to Finish video.https://www.youtube.com/watch?v=GAoUNNiLwKs Wheel Around videohttps://www.youtube.com/watch?v=XUL-m6Bramk They can't all be turn key! |
Thread Tools | |
Display Modes | |
|
|
Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.
MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.
This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC
All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.
Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.