PLEASE PATRONIZE OUR SPONSORS!
|
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Rejuvenating motor-driven PTO
Is it possible to clean out old grease, clean and regrease front motor driven pto?
|
#2
|
||||
|
||||
Not sure what kind of PTO you're referring to, but if it's a mechanical one I don't think it's supposed to have grease in it at all! Heck, I don't think electric ones should either!
__________________
'70 107 with k301 engine swap '71 106 with 38" deck '70 147R with factory replacement k321, 42" deck '61 Original with 38" timed deck '63 70 "pinkie" 1863 with 54" deck '46 Farmall H, '50 Farmall Cub 105 x2 (parts) |
#3
|
||||
|
||||
My bad, for the old narrow frames.
|
#4
|
||||
|
||||
Motor driven PTO bearing for 72, 104 and 124.
|
#5
|
||||
|
||||
.......lol, crickets?
|
#6
|
|||
|
|||
Clean and dry.
It's a friction device. If it is greasy you must have an engine oil leak nearby or the bearing is about to give up the ghost. |
#7
|
|||
|
|||
There is NO lubrication for a PTO, regardless if it is NF or WF, Mechanical or Electric.
__________________
Roland Bedell CC Models: 100, 105, 1450, 782, (2) 784, & 2072 Buy: Made in the USA |
#8
|
||||
|
||||
Personally, I'd just replace the bearing....I've been known to regrease bearings but not this one.
__________________
Two 125's and a 124 all with 42" decks Plow blade #2 Cart QA36 snowthower |
#9
|
||||
|
||||
Not familiar with your PTO. But a ball bearing can be re-lubed by using a Diabetic syringe filled with grease, injected under the seal lip.
Been doing it on old farm machinery for over 60 years. And the PTO bearings on my cubs. Yep I'm thrifty and it works. |
#10
|
||||
|
||||
Thanks ol' George.
|
|
|
Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.
MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.
This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC
All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.
Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.