PLEASE PATRONIZE OUR SPONSORS!
|
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Those plastic grills
About a year or so ago I put a new grill in my 2284. Doubt I have ran it over 10 hours since. Today I was tightening up the 2 bolts that stabilize the front axle and noticed one side has a crack under the bottom. Haven't ran into anything, nor do I think anything has ran into it under the shed. Wondering if I overtightened the grill when I installed it, or if its just a bad design. I don't remember any bad flashing that would have caused it to bolt down with excessive pressure, but can't swear to it.
Anyone else ever had this to happen or have an idea how to deal with it? I'm thinking that I will use some of the plastic welding type glue on it. Don't know if there is any way to reinforce it or not. Wonder if there is any product that I could use to "bed" the grill in place with? Thought about neoprene or using JB Weld to create a "nest" for it to sit in. Thought, ideas, suggestions?
__________________
2072 w/60" Haban 982 with 3 pt and 60" Haban 1811 with ags and 50C 124 w/hydraulic lift 782 w/mounted sprayer 2284 w/54" mowing deck |
#2
|
||||
|
||||
I doubt it's anything you did. They all break eventually. Most sooner than later.
__________________
Current: 86 102 122 1810 1862 1864 SZ60 Past: Original 71 72 73 100 102 122 123 124 125 127 129 147 149 169 383 582 682 782 782D 784 982 1000 1050 1100 1200 1210 1250 1415 1420 1440 1450 1535 1641 1650 1710 1711 1730 1806 1810 1811 1860 1861 1862 1864 1882 3185 3205 7265 |
#3
|
|||
|
|||
If the "grille" cracked in the center, under the opening, I suspect you slid the grille too far back on the frame and the grille bottomed out on the frame and cracked it. Don't know. Just an educated guess.
Since that thread, I've bought other tractors that have no plastic damage that are 25+ years old. You just can't ram them in to things or ham fist the plastic when you move the panels. |
#4
|
|||
|
|||
I'm guessing you have the factory metal plate with the two nuts welded on it in there? I have one I need to buy a grille for. really wish I new more about casting, I'd try to cast one in aluminum!
__________________
1782, 1862, 1440(sold), 89 1050, 128, 70, some run some don't! 72 scout IH 404 tractor |
#5
|
||||
|
||||
The plastic is pretty much why I decided I like the 82 series better.
__________________
1912 with Kohler M18 engine repower, CI rear, 50C deck, 364 snow blower IH Cub Original with deck #2 cart GREEN 314 with integral sleeve hitch, H2 and independent brake upgrade from a 317, and front hydraulic blade, 48" deck |
#6
|
|||
|
|||
I think the grills crack due to age and heat even if no impact. I have repaired with sections of PVC from electrical boxes. Unfortunately, the PVC is also affected by the heat.
Would fiberglass tolerate the heat and vibration? Could a form be made to duplicate in fiberglass?
__________________
1863, 1864, 48" and 54" mower decks, 54" snow plow, 451 snow blower, TracVac 580 |
|
|
Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.
MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.
This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC
All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.
Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.