2182 project

[red56turbo]

Paul,
I picked up a new hydraulic handle from my dealer last year for my 1782. Haven't gotten it on yet. Still in the package. I'll have to look and see what part number they have on it and post it here.

[Sam Mac]

Paul

I'm sure one of the sponsors would have the handle. Here are a couple pics. My guess is you need numbers 1,2,3+4

[Shrewcub]

Originally Posted by red56turbo

Paul,
I picked up a new hydraulic handle from my dealer last year for my 1782. Haven't gotten it on yet. Still in the package. I'll have to look and see what part number they have on it and post it here.

CC931-3100A $13.99 on Cub site.

[PaulF]

Originally Posted by red56turbo

Paul,
I picked up a new hydraulic handle from my dealer last year for my 1782. Haven't gotten it on yet. Still in the package. I'll have to look and see what part number they have on it and post it here.

Thanks Josh, that would be great

Originally Posted by Sam Mac

Here are a couple pics. My guess is you need numbers 1,2,3+4

Sam, that picture is just what I needed, thank you. Unless that nut and bolt is something special, the local hardware store has stainless examples for a tenth of the price.

Originally Posted by Shrewcub

CC931-3100A $13.99 on Cub site.

Ok cool Travis, thanks for looking that up

[red56turbo]

Yep Travis,
Just went and looked and its the 931-3100A. Guess I need to get around and get it on the tractor one of these days........

[J-Mech]

So..... why is it your putting it back stock?


I lost interest now...... have fun.

[PaulF]

Ummm...still using the 82 series hood and grill. The goal is to retain the tilt feature of the Cyclops dash.

Here's a picture of what I plan to replicate...trim the plastic from a cyclops dash and combine it with the top piece of plastic from an 82 series. Understand?

[PaulF]

Originally Posted by red56turbo

Yep Travis,
Just went and looked and its the 931-3100A. Guess I need to get around and get it on the tractor one of these days........

Does your replacement handle still have directions printed on the face?

[red56turbo]

Originally Posted by PaulF

Does your replacement handle still have directions printed on the face?

Nope. There's an outlined area where the decal goes, but no decal like the pic Sam posted. The PO of my 1782 had replaced the original handle with a bent piece of steel. I, too am eventually putting it back to stock. I never asked if you could still get the sticker. Bet someone's remaking them or could. Might even come in a decal set. Dunno.

[Tacosteelersman]

Check with the sponsors, maybe Rich Patton or one of the others could ship a good used one to you, it's not a heavy item.