|
PLEASE PATRONIZE OUR SPONSORS!
|
|||||||
 |
|
|
Thread Tools
|
Display Modes
|
|
#1
07-26-2016, 01:17 PM
|
|||
|
|||
Rewire IHC 782 Repower from KT17 to Mag 18
Hi, not sure if this is the right forum, but new to OCC and would like some help.
I'm repowering a IHC 782 from a KT17 Series 1 to a Mag18. My serial number is 20150594U686135. The engine swap went in fine. I need help with the wiring harness. The ignition switch is a 725-3026 and the KT17 had two wires, one to the coil and the other to the voltage regulator. From the old harness I can connect to the middle wire of the voltage regulator. But, I think I need to install a relay from the ignition switch to the ignition module. I also have a green oil pressure sensor on the engine. Here's a couple questions for those of you who have done this that perhaps can help; 1) What type and part number do I need for a relay? 2) can I use my existing ignition switch? 3) is it ok to leave the oil pressure sensor unconnected? Thanks, Bill 
|
|
#2
07-26-2016, 02:04 PM
|
|||
|
|||
|
As it was answered in this thread...... http://www.onlycubcadets.net/forum/s...662#post384662
Waiting on you.
__________________
[B]Roland Bedell[/B] CC Models: 100, 105, 1450, 782, (2) 784, & 2072 [SIZE="4"][B][COLOR="Red"]Buy:[/COLOR][COLOR="Blue"] Made in the USA[/COLOR][/B] [/SIZE]:American Flag 1:
|
|
#3
07-26-2016, 04:32 PM
|
||||
|
||||
|
Quote:
__________________
Terry O,100,72,102,123,104,124,105 125,129,149,1200,982 (2)2182s w/60in Habans 3225
|
|
#4
07-26-2016, 05:32 PM
|
|||
|
|||
|
Sorry, didn't see the Serial Number.
  All the diagram(s) and data was sent to the E-Mail Address listed in your profile. 
__________________
[B]Roland Bedell[/B] CC Models: 100, 105, 1450, 782, (2) 784, & 2072 [SIZE="4"][B][COLOR="Red"]Buy:[/COLOR][COLOR="Blue"] Made in the USA[/COLOR][/B] [/SIZE]:American Flag 1:
|
|
#5
07-27-2016, 09:47 AM
|
|||
|
|||
|
Thank you, on my way to getting this running !
|
|
#6
07-27-2016, 02:48 PM
|
|||
|
|||
|
Would either wjduggan2000 or Mr. Bedell send me the same wiring diagram for a M18 into a 782?
My recent 782 purchase (#679037) has a Kohler M18 (#1825206456) in it. Would like to double check the wiring in it to your diagram. Thanks in advance.
__________________
Stanton 1980 IH 782, Kohler M18 IH #1 Cart, original IH 42" Blade, modified to 50" and hydraulic 2015 XT2, Kawasaki 23 HP
|
|
#7
07-27-2016, 05:21 PM
|
|||
|
|||
|
Check your E-mail Acct that is listed in your profile.
__________________
[B]Roland Bedell[/B] CC Models: 100, 105, 1450, 782, (2) 784, & 2072 [SIZE="4"][B][COLOR="Red"]Buy:[/COLOR][COLOR="Blue"] Made in the USA[/COLOR][/B] [/SIZE]:American Flag 1:
|
|
| Tags |
| kt17, m18, rewire |
|
|
Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.
MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.
This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC
All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.
Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.
Linear Mode
