![]() |
PLEASE PATRONIZE OUR SPONSORS!
|
![]() |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
Well I was out in the shed last night putting Christmas away and went over to check out my 129. On the floor under the Hydro was a puddle of Hytran. It always leaked a little, but this was excessive.
On a previous post a month or so ago i asked about the breather on the Hydro. Tried cleaning it with Brakleen and a brush but I think maybe I just sealed it up like some of you suggested.Didn't run it much after that since winter set in. I'm thinking the leak is from the plugged breather and would like to adapt a 90 degree fitting with a tranny breather on the fill plug. Do any of you guys know what NPT the fill plug is? Thanks for your time, Joe |
#2
|
|||
|
|||
![]()
There is NO threads for that breather, It is a "press" fit.
__________________
[B]Roland Bedell[/B] CC Models: 100, 105, 1450, 782, (2) 784, & 2072 [SIZE="4"][B][COLOR="Red"]Buy:[/COLOR][COLOR="Blue"] Made in the USA[/COLOR][/B] [/SIZE]:American Flag 1: |
#3
|
||||
|
||||
![]()
jo1429
Do you mean what threads the fill/check plug has? I think its 1/2" pipe thread but cant remember for sure. I did that one time on the 169. Came out of the fill plug with an elbow then up a little to keep from sloshing out. Didn't make any difference on mine. It was leaking between the hydro and the rear. Had to replace the gasket. I did find a new breather to replace the original. I think R.F. Houtz is where i got it. |
#4
|
|||
|
|||
![]()
Yes, I meant the thread size of the fill plug.Thanks guys for your response. It really only became worse after I tried to clean the breather.
Joe |
![]() |
Thread Tools | |
Display Modes | |
|
|
Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.
MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.
This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC
All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.
Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.