|
PLEASE PATRONIZE OUR SPONSORS!
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
11-01-2015, 07:15 PM
|
|||
|
|||
100 drive shaft spinning
Hello from PA.
After reading many great and informative posts for a few weeks I finally have a question of my own. I picked up a '65 100 a few months back to be strictly my snow plowing tractor. She was pretty rough and had not ran in quite some time. Ever since she has been re-running, it would always grind going into gear and the drive shaft would still be turning with the clutch depressed. After noticing the teaser spring broke I decided a clutch rebuild was in order. I replaced the clutch disk, teaser spring, TO bearing, and refaced both clutch plates. After reassembly i continue to have the same result. If I start the tractor in gear with the clutch depressed all is good. It is when I pull it out of gear, with the clutch still depressed, that the shaft starts spinning. I'm certain the pressure plate is disengaging from the disk while the shaft continues to spin as I can see light between the two. It seems like it is binding in the pilot bushing, yet it is well lubricated. Warped shaft? Any thoughts? Thanks! 
|
|
|
Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.
MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.
This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC
All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.
Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.
Threaded Mode