|
PLEASE PATRONIZE OUR SPONSORS!
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
02-15-2014, 09:29 AM
|
|||
|
|||
127 axle seal change problems
My left axle seal was leaking on my 127, lost all the fluid in a day or two sitting in my garage. With 2 feet I snow on the ground I decide no time better to fix the tractor since all that snow I just shoveled could have been pushed out. I picked up two seals to just change both side while I was in there. So I've got the cub on stands, left tire and brakes off, tiller gearbox removed, and drained the rear except a little puddle. I pop of the Axle clip and wouldn't you know it vanished.... I searched for two hours last night, every crevices running magnets and a little mirror all around. I decide you know what I'll just pop the other side and see what happens, well it shot around inside the rear and I eventually found it in the small amount of fluid in the bottom. I gave up for the night so time to regroup.
1. Maybe somehow the clip flew past me and it's not in there? 2. I saw a video that shows a top access panel under the seat, any recommendations on the easiest way to pull the fenders? I was look at that last night and I've got some rusted flat heads on the foot boards- do those need to come off? I have been searching for a video or something on fender removal and have not had much luck. 3. Do I say oh well I have searched enough it's probably not in there, put a magnet in the housing just in case, get a new clip and let her rip? My rear main gear will not move, haven't been able to push the tractor but sporadically a few times last season. Any help would be greatly appreciated 
|
|
|
Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.
MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.
This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC
All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.
Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.
Threaded Mode