|
PLEASE PATRONIZE OUR SPONSORS!
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
03-23-2010, 10:27 PM
|
|||
|
|||
125 PTO lever side to side play
Hello,
I have a 125 that's having some issues with the PTO lever. The first time I used the tractor to cut some grass a few weeks back there was a horrible rapping sound. Turns out it was the PTO rod (with turn-buckle) slamming back and forth against the motor. This appears to be caused by excessive side to side play of the lever itself as the wear button contacts the PTO button. The button is brand new by the way. I also had a machinist friend replicate the fiber wear button out of brass. This seems to be a problem that was coming on over time as I recall hearing that rapping noise last year. The lever seems to be forced off center and it moves about a quarter inch to the left side (if you were sitting on the seat), then rattles badly back and forth. It is unusable until I figure out a fix. Question is: does the shaft or something wear and allow the entire lever to slide off horizontally off center? If so, what's the correct fix? These levers are about $116 for a new part! Also, I'm sure this has been covered before, but I cannot get the PTO bearing off the engine shaft. I know it's an eccentric collar and I can get the lock ring to rotate a little back and forth on the shaft, but the bearing will not budge. The old bearing seems to be OK, but I have a new one that I'd really like to install. Thanks very much for any advice! Tony 
|
|
|
Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.
MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.
This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC
All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.
Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.
Threaded Mode