![]() |
PLEASE PATRONIZE OUR SPONSORS!
|
![]() |
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
Running just fine as a pull tractor for a small trailer that I put on vegetable seedling flats on to transplant in the garden. Started up to return to the barn and would not move either in Forward or Reverse. towed back to barn with the tranny disengage lever proper position.
1. checked linkages which seemed ok. 2. checked fluid in tranny and noted to be very low. Refilled with Cub Cadet tranny fluid and no response when tranny engaged. 3. my CC contact suggested that the pump could have lost its prime in the tranny. Is there a technique to perform this or are we in more of a major diagnostic or repair project??? Thank You |
#2
|
|||
|
|||
![]()
Sound like you sheared a pin on the driveshaft. Very common.
|
#3
|
|||
|
|||
![]()
The charge pump does NOT need to be primed.
From what you are describing, I would suggest you look for this. Is the "output shaft" at the rear of the hydrostat unit rotating, at the same speed (RPM's) as the drive shaft...??
__________________
[B]Roland Bedell[/B] CC Models: 100, 105, 1450, 782, (2) 784, & 2072 [SIZE="4"][B][COLOR="Red"]Buy:[/COLOR][COLOR="Blue"] Made in the USA[/COLOR][/B] [/SIZE]:American Flag 1: |
#4
|
|||
|
|||
![]() Quote:
![]() |
#5
|
||||
|
||||
![]()
Going out on a limb here, have seen when run out of fluid, a little air pressure in the fill hole while running, brings back the prime, especially if the charge pump/hydro is worn.
just a rag around an air hose will usually do it. Keep in mind ya don't want to go over a pound or two pressure. You can do this AFTER you check for a sheared pin in the drive coupling. ![]() |
![]() |
|
|
Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.
MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.
This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC
All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.
Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.