Only Cub Cadets

PLEASE PATRONIZE OUR SPONSORS!

CC Specialties R. F. Houtz and Sons Jeff in Pa.

P&K Cub Cadet Machtech Direct

Cub Cadet Parts & Service


If you would like to help maintain this site & enhance it, feel free to donate whatever amount you would like to!




Go Back   Only Cub Cadets > Cub Cadets > IH Cub Cadet Tractors (GT)

Notices

Reply
 
Thread Tools Display Modes
  #1  
Old 06-19-2011, 07:25 PM
OverKnight's Avatar
OverKnight OverKnight is offline
Member
 
Join Date: Apr 2010
Location: New Jersey
Posts: 57
Default Unlocking 127 Transaxle

My worn-out 127 finally died. I could probably get it running with a carburetor rebuild and a new set of points and condensor (it's got a really weak spark but will barely sputter with starting fluid), but it's just worn out; time for the rebuild I've been planning. The problem is, though, it died at the far end of my yard, and I can't roll or tow it back to my shed. The tow lever to unlock the transaxle just freely swings back and forth. The manual shows that this lever is supposed to press down on one of the check valves; I'm guessing the part connected to the tow lever is no longer there. This check valve doesn't look easily accessible to manually depress it.

So, how can I roll this thing back to my shed?

Thanks.
Reply With Quote
  #2  
Old 06-19-2011, 07:28 PM
william1041200's Avatar
william1041200 william1041200 is offline
Senior Member
 
Join Date: Aug 2010
Location: MD
Posts: 1,029
Default

you could push a wedge between tunnel cover and something to push the release valves down from the back. Or trailer it.
__________________
104 to 127 conversion with dual 6x12s, hydraulics
snow/dirt plow
1200 Quietline 44" mower
QA-36 snow thrower
Reply With Quote
  #3  
Old 06-19-2011, 10:19 PM
darkminion_17's Avatar
darkminion_17 darkminion_17 is offline
Grand Member
 
Join Date: Aug 2010
Location: New Jersey
Posts: 11,221
Default

You could always move the shed.
I find that eventually they roll very slowly .If you can get at it with a car or truck you could drag it back to the shed .Put a cut up piece of a plastic milk container under each rear wheel and it will slide on the grass.
__________________
Up to 530 and counting...
I give up updating my profile!
Reply With Quote
  #4  
Old 06-19-2011, 11:16 PM
young enthusiest's Avatar
young enthusiest young enthusiest is offline
Senior Member
 
Join Date: Mar 2009
Location: AB
Posts: 632
Default

Lift on one side while pushing. One wheel will turn backwards
__________________
Tyler Chiliak. Southeast Alberta Canada.
My dad and I own, 1650, , 1450, 1250, 1250, 1200, 982, 782, 149, 149, 149, 128, 128, 123, 100, 100. Also a 1310, 1500, and 2 1600 IHC trucks.
Reply With Quote
  #5  
Old 06-20-2011, 08:29 PM
OverKnight's Avatar
OverKnight OverKnight is offline
Member
 
Join Date: Apr 2010
Location: New Jersey
Posts: 57
Default All good suggestions.

Even moving the 9 x 11 shed (with a 4 x 11 porch); it might be lighter than the 127...

I'm going to try the wedge trick first. If that doesn't work, I might try picking up the back end with a hand truck. I'll let you know how it goes.
Reply With Quote
  #6  
Old 06-20-2011, 10:28 PM
darkminion_17's Avatar
darkminion_17 darkminion_17 is offline
Grand Member
 
Join Date: Aug 2010
Location: New Jersey
Posts: 11,221
Default

what part of NJ are you from?
__________________
Up to 530 and counting...
I give up updating my profile!
Reply With Quote
  #7  
Old 06-21-2011, 11:58 AM
OverKnight's Avatar
OverKnight OverKnight is offline
Member
 
Join Date: Apr 2010
Location: New Jersey
Posts: 57
Default Unlocking 127 Transaxle

Marlboro, in central Jersey.
Reply With Quote
  #8  
Old 06-21-2011, 10:01 PM
darkminion_17's Avatar
darkminion_17 darkminion_17 is offline
Grand Member
 
Join Date: Aug 2010
Location: New Jersey
Posts: 11,221
Default

Ahhh do you know Jason La Fante??
__________________
Up to 530 and counting...
I give up updating my profile!
Reply With Quote
  #9  
Old 06-21-2011, 10:44 PM
OverKnight's Avatar
OverKnight OverKnight is offline
Member
 
Join Date: Apr 2010
Location: New Jersey
Posts: 57
Default

Not yet...
Reply With Quote
  #10  
Old 06-25-2011, 10:45 PM
OverKnight's Avatar
OverKnight OverKnight is offline
Member
 
Join Date: Apr 2010
Location: New Jersey
Posts: 57
Default Unlocking 127 Transaxle

Well, I got her running and back to the shed...

I knew the ignition was weak, and since I planned on upgrading to the Chevy-style points, I ordered the bracket and cover, and today bought a set of points. The points bracket and cover installation were not exactly simple; in fact, I removed them and will contact the vendor to resolve a few issues with them. I cleaned up the old points and reinstalled them. I also installed a new spark plug. While I was playing around, I did a quick clean-up of the Walbro carburetor, and since the carb was off, I adjusted the valves; both were a little tight. I put everything back together and... no spark. I checked the wiring (which will also require replacement), and 12.6 volts were getting to the coil. Just for yuks, I installed an old coil, condenser and spark plug wire from my '57 Chevy, and now there finally was a nice fat spark. When I tried to start her up, it was spitting back through the carb; re-setting the points cured that. She then started right up and ran more smoothly than ever.

I have one or two more jobs I'll need the Cub for, but as soon as they're finished, I'm going to pull the engine and do a complete rebuild. The blowby is so bad, you get an oil shower when the dipstick is pulled out...
Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 02:52 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.

Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.

MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.

This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC

All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.

Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.