I picked up my QA42A yesterday and it looks to be ready to run but I'm planning a few maintenance checks.
The auger has a few dings so I'll get out the hammer and dolly.
The chute didn't rotate smoothly so I removed it, cleaned out all the old hard grease and spayed silicone everywhere. The shell opening was a little egg shaped so it got a few love taps where it was binding on the chute. I also re-greased the chute sprocket and now it rotates pretty well.
The auger bearings and drive shaft are nice and tight. I noticed about 1/4"of pulley rotation slop from the gearbox. Is that OK and should I pull the cover, clean it out and re-grease it? Oil or grease, any way to tell?
The zerk is broken off the drive shaft near the splines where it expands so I will need an easy out to replace it.
The drive gear bracket should be removed and inspected. The bolts and pivot will need anti-seize since steel and aluminum don't play nice together.
__________________
Rusty 149 project with:
QA42 snow thrower
38" deck
Barn fresh 1811 with:
44c mowing deck
QA42A snow thrower
42" snow blade
|