View Single Post
  #10  
Old 05-09-2015, 09:18 PM
BThein's Avatar
BThein BThein is offline
Senior Member
 
Join Date: Mar 2009
Location: PA
Posts: 194
Default

I drilled out the rivets on my 982 with the Onan and sealed it up with black high temp Permatex that was rated for use in gas and oil. I used small screws and nuts with lock washers and a dot of locktight on each. Put it all back together with new intake gaskets and carb rebuilt. After that it ran great, just inspect the intake well mine had hairline cracks and I had to make one good one from two bad.

Bob
Attached Images
File Type: jpg 982 Engine Mods 002 (Small).jpg (28.5 KB, 78 views)
Reply With Quote