Thanks JM - I did talk to a few people in the CC circles today and confirmed that at least the drawbar plate was being reproduced awhile back, but it looks like when demand dried up, so did production. I might be able to get a copy of the fabrication drawings that were used, but not counting on that, so it looks like I'll be working up something to get from Point A to Points B and C, so to speak.
Thinking maybe I'll get the shape of the pivot pipe with easier-to-manipulate PVC first unless someone on the board here with a Haban is nice enough to take some measurements of it and the drawbar plate. Maybe these are even less common than I thought? Seem to get a few hits on others with them when searching the site.
|