18hp B&S Vanguard in 782
Looking for any information about wiring a 18hp B&S vanguard into a 782.
I have a 782 that did not have an engine and found one that already had been in a 682. The only information the guy I purchased the engine from said all I needed was a 6 prong ignition switch and make the drive shaft about 1 inch longer. The motor mounted right in and I have a switch ordered but not sure how to wire the new switch to the vanguard or what changes I need to make to the current wiring harness.
I don't think this was a kit when he purchased. I have a red wire coming off of the regulator, another red wire that goes into the shroud, and a white wire that is screwed to white plastic on shroud.
any information is appreciated.
Thank
Scott
|