View Single Post
  #27  
Old 02-28-2021, 05:14 PM
DRohacek DRohacek is offline
Member
 
Join Date: Feb 2021
Location: Virginia
Posts: 64
Default

Quote:
You fellas have access to some very affordable hydraulic components. And like sawdustdad said, these are toys, not production machines.
Definitely a float valve would be an asset on the blade height cylinders. I could be wrong, but I believe you could add one after the tractor's original valve.


I had thought about float but at this point I am going without it.
At this point I can raise and lower the blade, tip it right or left(up or down), angle it left or right, skew it to the right and angle it to cut a ditch or up to grade a bank.
The blade can roll forward also to make the cut less aggressive and more of a finishing step.
Reply With Quote