View Single Post
  #8  
Old 05-15-2022, 12:19 PM
Sergeant's Avatar
Sergeant Sergeant is offline
Senior Member
 
Join Date: Aug 2010
Location: Wayne, IL
Posts: 352
Default

Basically the 2000 series from the 1990s through the Current XT3 series is the same, except there was a Frame cross Member By the Trans Mission On the early 2000 & 2500 series frames. That was dropped On the Later 2000 & XT3 series Frames 2011 and after

The rear Hitch Plate on the Later 2011 and after 2000 & XT3 series is different as You Cannot accommodate the older OEM Electric Lift sleeve Hitch or 30 inch Hydraulic tiller. But I bet the Older 28-inch PTO tiller from the Original 2000 series will fit Because it Mounted Into the Rear Frame rails and not on the Outside of the Frame All Other attachments such as the front Mounted Blade, Blower & thrower will work on a XT3 series today so will the Original front & rear weight brackets for the Pre-2011 2000 series. Just as the XT3 series Manual lift sleeve Hitch will work On the Older Pre-2011 2000 & 2500 series

The 3000 series was Built On a different 9 gauge Frame design which is similar to the Pre-2011 2000 series and 2500 series which were On an 11 gauge Frame But there are extra cross Members On the 3000 series frame as well

The 2011 and after 2000 series uses the GT3100 Transmission final drive But with a BDU 10 Pump instead of a BDU 21 found on the GT3100 tractor
__________________
0riginal, 60 RER, 70, 106, 1450, 2182, 3208, XT3GSX & SX54 Z Force
Reply With Quote