View Single Post
  #14  
Old 03-15-2019, 07:12 PM
athomas's Avatar
athomas athomas is offline
Senior Member
 
Join Date: Dec 2011
Location: New Florence, PA
Posts: 540
Default

Quote:
Originally Posted by ironman View Post
Personally speaking, with the tractor sitting on a level concrete surface with the deck lowered all the way, I find it frikken' impossible to measure the blade height other than the one at the chute. How are you supposed to measure where you can't get your hand or see? They should sell a trained mouse that you send in there with a gauge. Maybe I could place lumps of clay under the blade tips, lower the deck, then remove and measure the thickness of the clay. Does anybody have an easy way of doing this or is it just me?
Agree, tough to measure, but I pick it up where I can reach under with a tape,doesn't matter if its up, still hangs the same on the frame ? keep some drag on the tape,reach under and pull it up till it touches the bottom of the blade then pull it out and read it ,
Reply With Quote