Quote:
Originally Posted by Rjwpavo
Ken,
I still haven't gave up looking around here for a shop. I can definitely do the assembly part, just not the machining. The folks up north have it made as far as Cub Cadet/Kohler/GT pulling stuff!
|
Quote:
Originally Posted by mortten
I have not but plan to. Delta Cub , a member here, I believed used them for some machining services.
|
I have used Kustom Lawn and Garden for engine machining. I have yet to finish the engine project. From all preliminary checks, the machining was done properly. The prices were reasonable and the turn around was quick. These guys specialize in Kohler "K" series engines. here is my thread on this rebuild.
https://www.onlycubcadets.net/forum/...t=56147&page=3