Step 26: Install external governor components and throttle controls
The governor arm goes on the shaft and is left loose for the time being:
The spring on my K341 was originally located on the third hole up from the bottom. I recall reading somewhere that it appears to be the same for most all Kohlers, but this is one of those things you're going to want to get pictures of before disassembly, so you'll know how it goes together correctly.
Then the controls are bolted up to the blower housing:
And the spring connects in the second hole from the top on my engine (again, good stuff to get pictures of before disassembly to assure your correct holes.)
(This pic was taken a little late, after the carb was already on - of course, we haven't put the carb on yet. On to the next step...)