Quote:
Originally Posted by Sugarmaker
Duke, Larry Thanks
Todd,
I have made only one design change to the Cub for the seat. I added (2) 2 inch aluminum spacer blocks at the rear of the seat spring to avoid the spring flexing and causing the adjustable seat rails to bind. Not sure how harsh the ride will be? Other than that and no seat time yet. I like the seat a lot. I think it will work very well.
OK guys (Dave) straighten me out on the procedure for timing one of these. Book says just bring it to TDC when the points are full open and set them to .020. So far that's all I have done.
I didnt even look for timing mark in the side cover hole.
Did get a 2 hours in the deer stand yesterday (zip). And spent the rest helping Eric side his house restoration project. No CUB time this weekend.
Regards,
Chris
|
Chris good luck and enjoy yourself in the deer stand.
I would use Matt's guide to time to motor or I would use a timing light.
http://www.onlycubcadets.net/forum/s...ead.php?t=4405