Quote:
Originally Posted by krhoover
Talked with the guys in the toolroom at work today, they said the would cut a new keyway into the crank on this. The one guy says he thinks he can do it without taking it out of the engine. The question is, does it matter where the new keyway is cut? I mean can it be 90 or 180 degrees from the old one. Also, since I am going to be pulling the motor, any other parts that I should be replacing? I plan on tune up parts. Thanks
|
I can't think of a reason why it could'nt be cut anywhere, most cut the new ones 180 degrees from the old one.
__________________
Jeff
Brookfield, MO
________________
IH Red 782 with weights and sleeve hitch!
IH snow blade, Brinly plow, Brinly disk, Brinly harrow, Johnson rear blade, and a #2 IH Cart
|