Should be able to get to the broken parts by unbolting the motor from the frame. You may have enough slack in your fuel line, wiring harness, and choke/throttle cable to slide the engine forward about 3/4-1" to get the drive shaft to drop out of the pin cup. You will need to remove the mesh cover that attaches to the frame that covers this area to make accessing the offending parts easier. If anything is holding you up from sliding the engine forward, just unhook those items. If you want to remove the entire drive shaft you will have remove the engine and unbolt it at the hydro pump from underneath the tractor, remove 2 bolts from the flex disk.
__________________
Jeff
Brookfield, MO
________________
IH Red 782 with weights and sleeve hitch!
IH snow blade, Brinly plow, Brinly disk, Brinly harrow, Johnson rear blade, and a #2 IH Cart
|