Ahhhh, yea Its completely missing that big piece of metal to puch down on the check valve. I can feel the rod spinning but its not connected to anything. So now I know what I need to Fab up.
For the PTO Handle I looks like my Item 9 is broken right after making the turn to go up. I can't really see what the rest of it is, its very small
New question. Currently to start the tractor you jump a wire from the Battey + to one of the Gen/Sta terminals and it turns over. I went through and fixed some of the wiring, but it looks like my starter solienoid is junk, so I am going to get a new one of those. But in my re-wire I cannot figure out two wires. One has 12Volts with the key on coming from the harness into the colum area. and the other seams dead. Both of these were connected to the small start post of the solenoid before. But it would have made the starter turn over with just the key in the on position (if the soleinoid worked). I am thinking it might have something to do with a nuetral safty switch, I see it in my wiring diagram but I cannot find the switch on the tractor, any Ideas where it would be?
|