[nycub122]

Need to do some repairs on my Cub 122 and have a couple of questions:

1) I understand that the front axle supports on the frame will spread out over time and need to be drawn in to eliminate horizontal axle play, resulting in better steering. I have seen threads here that suggest using a 3/4" grade 8 bolt to draw the supports in. Can this be done, once the axle pivot pin is removed, with the axle still in place? Also, can I substitute a 3/4" grade 8 bolt for the axle pivot pin, which would allow me to make adjustments in the future, if needed?

2) I have looked at the parts diagram for the clutch system and see no mention of a washer or spacer between the clutch loading spring and the clutch throwout bearing. Does the end of the loading spring make direct contact with the face (large side) of the throwout bearing? I would think that some kind of thrust washer is needed to prevent failure of the throwout bearing. Any ideas?

Thanks
GEL